Press Ctrl / CMD + C to copy this to your clipboard.
This post will be reported to the moderators as potential spam to be looked at
Hi.
I have a solution where insertion a macro into content or accessing nodes that have a macro is realy slow.
Typical it takes 30 sec or so before anything happens. I've had a look at the umbraco error log but cannot see anything suspicious.
Any ideas?
What is in the macro?
The original problem was with a contour macro but I've tried with a very simple macro aswell that just outputs a link.
It is a version 4.0.4.2 installation btw.
It seems to be an issue across several solutions that run on the same IIS and up against the same SQL server.
Is it the backend thats slow or the front end? If the front end you might try accessing the page with ?umbdebugshowtrace=1 and seeing if you can see where the slowdown occurs
Hi Tom.
It's in the backend.
I've just fiured out that if if you deselect "Render content in editor" on the macro everything is fine
Kristian, thanks so much for the tip. I was trying to figure out the same thing.
is working on a reply...
Write your reply to:
Upload image
Image will be uploaded when post is submitted
Working with macros is slow
Hi.
I have a solution where insertion a macro into content or accessing nodes that have a macro is realy slow.
Typical it takes 30 sec or so before anything happens. I've had a look at the umbraco error log but cannot see anything suspicious.
Any ideas?
What is in the macro?
The original problem was with a contour macro but I've tried with a very simple macro aswell that just outputs a link.
It is a version 4.0.4.2 installation btw.
It seems to be an issue across several solutions that run on the same IIS and up against the same SQL server.
Is it the backend thats slow or the front end? If the front end you might try accessing the page with ?umbdebugshowtrace=1 and seeing if you can see where the slowdown occurs
Hi Tom.
It's in the backend.
I've just fiured out that if if you deselect "Render content in editor" on the macro everything is fine
Kristian, thanks so much for the tip. I was trying to figure out the same thing.
is working on a reply...